Installing WinRT for Windows NT 4.0 and Windows 2000

1. Run "setup.exe"
2. Follow all defaults.
3. To remove the driver use "Add/Remove Programs" in Control Panel 
 

Win RT Settings

Install Parallel port Virtual Device Driver to enable Printers and Plotters in Isis.
Install ISA Bus DSP1 Virtual Device Driver to enable TritonElics ISA bus DSP card in Isis
(for recording data via DSP card in Isis)

These are the normal settings for a Shipboard Isis with 1 DSP card, and realtime plotting.

Double click Win RT registry icon, or launch from start menu.
This will Launch WinRT Registry.

PARALLEL PORT VIRTUAL DEVICE DRIVER (Assumes standard LPT1 on I/O 378 and Interrupt 7)

1. Click Device > New
2. Click window below port address
3. Enter "378"
4. Click window below port count.
5. Enter "4"
6. Click OK at the prompt.
7. In Interrupt Number enter "7"
8. Check the box "Allow conflict" under ADVANCED
9. Click device > Save


ISA Bus DSP1 VIRTUAL DEVICE DRIVER

1. Click device > New
2. Click window below port sddress
3. Enter "280"
4. Click window below Port Count
5. Enter "10"
6. Click device > Save
7. Click OK at the prompt.

SETTING THE STARTUP

1. Click Driver > Set Startup
2. Click Automatic
3. Click OK
4. Click File > Exit
5. Click OK at the prompt.


NOTE: System must reboot once before TritonElics software will run.